Keithley 2001 User Manual

SCPI Conformance Information
J-8
:CALibration
:PROtected
:LLEvel
:STEP <Step #>
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
:STEP?
:CALCulate
:DC
:ZERO
:LOW <NRf>
:HIGH <NRf>
:LOHM <NRf>
:HOHM <NRf>
:OPEN
:CALCulate
:UNPRotected
:ACCompensation
:DISPlay
[:WINDow[1]]
:DATA?
:WINDow2
:DATA?
:CNDisplay
:SMESsage <b>
:SMESsage?
:FORMat
:ELEments <item list>
:ELEments?
:OUTPut
:TTL[1]
:LSENse <name>
:LSENse?
:TTL2
:LSENse <name>
:LSENse?
20V AC at 1kHz step.
20V AC at 30kHz step.
200V AC at 1kHz step.
200V AC at 30kHz step.
1.5V AC at 1kHz step.
0.2V AC at 1kHz step.
5mV AC at 100kHz step.
0.5mV AC at 1kHz step.
+2V DC step.
-2V DC step.
0V DC step.
20mA AC at 1kHz step.
+0.2A DC step.
+2A DC step.
2V AC at 1Hz step.
Request the current calibration step.
Calculate low-level cal constants.
User calibration subsystem.
Low-thermal short calibration step.
+2V DC calibration step.
+20V DC calibration step.
20k Ω calibration step.
1M Ω calibration step.
Open circuit calibration step.
Calculate DC cal constants.
All commands in this subsystem are not protected by CAL switch.
Perform user AC calibration (disconnect all cables).
Path to locate message to top display.
Query data on top portion of display.
Path to locate message to bottom display.
Query data on bottom portion of display.
Clear NEXT (or PREV) display messages and cancels associated operations.
Enable (1 or ON) or disable (0 or OFF) status message mode.
Query status message mode (0 or 1).
Specify data elements: READing, CHANnel, RNUMber, UNITs, TIMEstamp and STATus.
Query data elements.
Path to set polarity of digital output line 1:
Select polarity; active (AHIGH) or active (ALOW).
Query polarity of line 1.
Path to set polarity of digital output line 2:
Select polarity; active (AHIGH) or active (ALOW).
Query polarity of line 2.
Table J-2 (cont.)
Syntax of non-SCPI commands implemented by Model 2001
Command Description

Keithley 2001 Specifications

General

Brand	Keithley
Model	2001
Category	Multimeter
Language	English