EasyManuals Logo

Keysight DAQ970A User Guide

Keysight DAQ970A
232 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
Step Front panel Remote interface
1 Press [Home] > User Settings > I/O > LANSettings > Modify
Settings.
Set the first softkey to Manual and press Host Name to enter
the hostname.
SYSTem:COMMunicate:LAN:HOSTname
2 If you change this parameter, you must press [Done] > [Done]
> [Apply Changes] for the change to take effect.
SYSTem:COMMunicate:LAN:UPDate
Each instrument is shipped with a default host name with the format: K-modelnumber-serialnumber,
where modelnumber is the instrument’s 7-character model number (e.g. DAQ970A), and serialnumber is
the last five characters of the 10-character instrument serial number located on the label on the top of the
unit (e.g. 5678 if the serial number is MY12345678).
l The instrument receives a unique hostname at the factory, but you may change it. The host-
name must be unique on the LAN.
l The name must start with letter, other characters can be an upper or lower case letters,
numeric digits, or dashes "-".
l This setting is non-volatile, it will not be changed by cycling power, factory reset (*RST com-
mand), or instrument present (SYSTem:PRESet command).
IP Address
You can enter a static IP address for the instrument as a four-byte integer expressed in dot notation. Each
byte is a decimal value, with no leading zeros (for example, 169.254.2.20). Refer to "More about
IPAddresses and Dot Notation" for further details.
Step Front panel Remote interface
1 Press [Home] > User Settings > I/O > LANSettings > Modify
Settings.
Set the first softkey to Manual and press IP Address to set the
desired IP address.
SYSTem:COMMunicate:LAN:IPADdress
1 Introduction to the Instrument
26 Keysight DAQ970A User's Guide

Table of Contents

Other manuals for Keysight DAQ970A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keysight DAQ970A and is the answer not in the manual?

Keysight DAQ970A Specifications

General IconGeneral
Scan RateUp to 450 channels/sec
ConnectivityUSB, LAN, GPIB (optional)
Display4.3-inch color LCD
Operating Temperature0 °C to 50 °C
Number of slots3 slots
Measurement TypesDCV, ACV, DCI, ACI, 2-wire resistance, 4-wire resistance, frequency, temperature, capacitance
Voltmeter6.5 digit
Resolution22 bits
MemoryNon-volatile memory