Keysight DAQ970A User Guide

Step Front panel Remote interface
1 Press [Home] > User Settings > I/O > LANSettings > Modify
Settings.
Set the first softkey to Manual.
SYSTem:COMMunicate:LAN:DHCP OFF
2 If you change this parameter, you must press [Done] > [Apply
Changes] for the change to take effect.
SYSTem:COMMunicate:LAN:UPDate
Host Name
IP Address
Subnet Mask
Gateway
Primary and Secondary DNS
Primary and Secondary WINS
Service mDNS
Host Name
A hostname is the host portion of the domain name, which is translated into an IP address.
Keysight DAQ970A User's Guide 25
1 Introduction to the Instrument

Keysight DAQ970A Specifications

General

Scan Rate	Up to 450 channels/sec
Connectivity	USB, LAN, GPIB (optional)
Display	4.3-inch color LCD
Operating Temperature	0 °C to 50 °C
Number of slots	3 slots
Measurement Types	DCV, ACV, DCI, ACI, 2-wire resistance, 4-wire resistance, frequency, temperature, capacitance
Voltmeter	6.5 digit
Resolution	22 bits
Memory	Non-volatile memory