tighten the screw F
(Tightening torque of 8 Nm -
Fig. 10.7 ).
5.
Start the engine without the
radiator cap A or the
expansion tank (C) cap B.
6.
Keep the engine at idle speed
or without a load until the
coolant level goes down and
becomes steady (the waiting
times varies according to the
ambient temperature).
7.
Turn off the engine and allow
it to cool.
8.
If there is an expansion tank
(C) top liquid up to the mark
MAX .
9.
Without expansion tank top
liquid up until the pipes inside
the radiator are covered by 5
mm. Do not overfill the
radiator, but leave room for
the coolant to expand.
10.
Tighten the radiator cap A or
the expansion tank (C) cap B.
Warning
Before starting make sure that
the radiator cap and
expansion tank cap, if
present, are installed correctly
to avoid loss of liquid or
vapour at high temperatures.
1.
After a few hours of operation
stop the engine and allow it to
cool.
Check and top up the coolant.
To Next Page
Loading...
