Kohler KDI 1903 TCR

243
EN
11.2 Heater (replacement)
Important

Before proceeding with operation, read Par. 3.3.2 .
11.2.1 Disassembly
1.
Undo the screws A and the relevant washers and
remove the earth cable B .
2.
Remove the flange C and the manifold D .
3.
Remove the heater E and the relevant gaskets F .
Fig 11.6
11.2.2 Assembly
Important

Always replace gaskets F , with each assembly.
1.
In sequence, fit the manifold G with the gasket F , the
new heater E , the second gasket F , the flange C , the
washers H , the screws A and the cable B .
2.
Secure the flange H with the screws A (tightening torque
at 22 Nm ).
3.
Secure the earth cable B with the nut J and the relevant
washer on the heater E .
Fig 11.7