Kohler KDI 1903 TCR

EN
130
6.11 Fuel filter replacement
6.11.1 Disassembly
Important

Before proceeding with operation, read Par. 3.3.2 .
Warning

The fuel filter is not always mounted in the engine.

When disassembling the sensor E , use a suitable
container to recover the fuel contained in the cartridge
F .
1.
Release the clamps A and pull the pipes B out of the
support H .
2.
Unscrew the sensor E from the cartridge F .
3.
Unscrew the cartridge F from the support H .
4.
Undo the screws C and remove the support H .
Fig 6.74
Fig 6.75
Warning

Check that the fuel supply pump filter is present, and
replace if necessary.
1.
Release the clamp D .
2.
Demount the hose E .
3.
Unscrew the filter G from the pump Q .
1.
Screw the new filter G onto the pump Q (tightening
torque 20 Nm ).
2.
Connect the hose E to the filter G and fasten with the
clamp D .