Material that has undergone surface protection treatment.
Grinding (valves and
seats):
Cleaning operation of the valves and seats carried out with an abrasive paste (refer
to an authorised service station for this type of operation).
H
A device that heats the intake air by means of an electrical resistor.
Type of extreme condition referred to the work environment in which the engine is used
(very dusty - dirty area, or in a contaminated environment due to various types of gas).
I
Operation of a running engine with the vehicle stopped and on idle speed.
Air-cooling element under pressure from the turbo situated between the turbine and
intake manifold.
K
"Kohler Direct Injection"
M
A group of maintenance actions that have the sole objective to control and replace
elements on their expiry, without modifying or improving the functions carried out by the
system, neither increasing the value nor improving performance.
It is a mixture of products by means of a chemical conversion of oils and animal and/or
vegetable fat, which is used to produce Biofuel.
Model, engine identification plate, which indicates the engine's model.
N
Normally Closed, referred to switches (oil-pressure switch).
O
To Next Page
Loading...
Need help?
General