76
activate or deactivate the Automatic status page reload.
Related topics
GNSS management: Data streams
Receiver setup: Spider and remote access
Receiver setup: FTP server
Receiver setup: Web server
Status: Antenna
Background information
This page displays the currently configured antenna for this site.
Field Description
The table below describes the fields in the Status: Antenna page.
The information shown is dependent on the antenna selected in GNSS management: Antenna management on the Select antenna
tab.
The currently configured antenna.
Shows if the configured antenna is a default antenna or a user defined antenna.
Shows the IGS name of the antenna as it will appear in the RINEX header.
The antenna height reading.
The measurement type used for the height reading, either Vertical or Slope.
The distance from the physical reference point to the point the height reading is measured to
on the antenna.
Shows the horizontal offset for slope height readings.
To enable or disable the automatic update of the status page, please go to Receiver setup: Web server and
activate or deactivate the Automatic status page reload.
Related topics
GNSS management: Antenna management
Status: Event log
Background Information
The Event log contains a list of status and information messages produced by the receiver. The Event log is updated every 5 seconds.
The messages from the Event log can be sent to an administrator via an event email. Sending event emails can be configured and
activated via Receiver setup / Event log.
Event log messages can be filtered to easily find specific information.
Field Description
To Next Page
