Leica GR30 - Setting Descriptions; Remote Access Wizard: Set Port Status; Ntrip Caster

6: Context sensitive help
165
GSM (Global System for Mobile communications) is a telecommunication standard for transmitting data packages to mobile phones.
CDMA is a telecommunication standard for transmitting data packages using the Internet protocol.
Setting Descriptions
The table below describes the settings that can be configured on the Configure GSM / Modem / CDMA page.
Setting
Description
Device
Select the device to be used. The list shows all GSM / Modem / CDMA devices configured in
the device management.
PIN code
Enter the PIN (personal identification number) code for the device's SIM card.
PUK code
The PUK (PIN unblock key) code is a security code for the SIM card used on some devices.
The PUK code needs to be entered when the PIN code has been entered incorrectly more
than three times and the SIM card is blocked. The PUK will unblock the SIM card.
This field can normally remain empty.
Connected to
Only available on the GR25/50.
Select the physical serial port for data transmission
• Serial port 1
• Serial port 2
For the GR10/30 & GM10/30, Serial port 1 is configured
automatically as there is only one serial port available.
For slot in devices, this field is not available, the slot-in port is
selected automatically.
Press to go back to the previous wizard step. Press to continue to the next wizard step.
Press to cancel and return to Spider and remote access: Overview .
Remote access wizard: Set port status
Setting Descriptions
The table below describes the settings that can be configured on the Set port status page.
Setting
Description
Activate remote access
Deactivate the port configuration if you do not want to open the port immediately.
Press to go back to the previous wizard step.
Press to store the new remote access configuration and return to Configuration: Spider and remote access: Overview.
Press to cancel and return to Configuration: Spider and remote access: Overview.
Ntrip caster