Leica GR30 - Configure a Data Stream Step-By-Step

5: Getting started
57
activate the check box if Doppler observations should be logged. Then use the Continue button.
7
On the following page you can choose if the logged files should be zipped, you can select a directory naming
convention, choose an FTP location where the files should be sent to and set an interval after which the files
should be deleted from the memory device.
Note that you have to set up an FTP location on page GNSS management / FTP location before you can
choose it in the respective list box.T hen use the Continue button.
8
On the last page of the wizard you can activate the logging session. In this case the logging will immediately
start. If you do not activate the check box Activate session the session will be saved with all its settings but
it will not be started. Press the Save changes button to save all settings.
Configure a data stream step-by-step
This section explains how to configure a new outgoing real time data stream using a radio.
Step
Description
1
Access the web interface.
2
Go to page GNSS management / Data streams.
3
Use the button Create a new data stream .
4
The outgoing data stream wizard will start.
5
Select Real time in list box Data stream type. Press Continue .
6
On the next page select a message format, version and message types (if available). Here you can also
configure a reference station ID, the end of message settings, enable time slicing and choose the message
rates. When finished press the Continue button.
7
On the following page you can choose the type of data transmission, e.g. TCP/IP, modem or radio. Select Radio
and press Continue .
8
The next page allows selecting a specific radio from the list of configured radio devices. Besides this, the radio
channel can defined. When finished press the Continue button.
9
On the last page of the wizard you can activate the stream or just save the settings without staring the new
stream. Press the Save changes button to save all settings.
After installing the dual frequency option, the configured data streams must be restarted to enable both L1
and L2 streams.