132
If the FTP push was successful, a message is displayed in the event log and the FTP push queue number is updated.
GNSS management: Antenna management
GNSS management: Antenna Management overview
Select an antenna and enter the height reading and measurement type.
Upload new antenna files, create new antennas and restore antenna
default values.
GNSS management: Select antenna
Background information
Select the antenna currently connected to the receiver and enter the height reading and measurement type.
Correctly specifying the antenna and related information is critical for high accuracy positioning.
Changing the antenna type and/or antenna height interrupts logging and streaming. If any of these settings
are changed when a logging session is active, then the current files will be finalized and new file(s) will start
to be logged.
Field Descriptions
The table below describes the fields in the Select antenna tab.
Calculate the antenna height reading contains detailed information for the Height reading and Measurement type.
From the list box select the antenna to be used with the receiver.
The list contains all default and user defined antennas. Go to Antenna management to upload a
new antenna file or manually define a new antenna.
Enter the antenna height reading.
The antenna height reading must be measured as true vertical height.
Related topics
GNSS management: Antenna management
Create/Edit and Antenna
GNSS Management: Calculate the antenna height reading
GNSS management: Antenna management
To Next Page
