180
Device Management: GPRS / Internet initialization
Setting Descriptions
The table below describes the settings that can be configured on the GPRS / Internet initialization page.
This page is only shown when Mobile internet capable is set to Yes on the New / Edit modem/phone page.
Enter a valid AT command to initialize the device.
Enter a valid AT command to initialize the device.
Enter a valid AT command to connect to the internet.
Press to continue to the next wizard step.
Press to cancel and return to Device Management: Modem / Phone
Device Management: GSM / CSD initialization
Setting Descriptions
The table below describes the settings that can be configured on the GSM / CSD initialization page.
Enter a valid AT command to initialize the device.
Enter a valid AT command to initialize the device.
Enter a valid AT command to connect to the device.
Enter a valid AT command to end the network connection.
Enter a valid AT command to switch into command mode before using the hangup string.
Press to change settings.
Press to save the logging session.
Press to cancel and return to Device Management: Modem / Phone
Receiver setup: Event log
Background Information
The Configuration: Event log page is used for configuring and editing the settings for sending automatic event emails containing all
messages from the event log.
The page also allows settings the automatic delete interval for all event log messages.
Setting Descriptions
The table below describes the settings that can be configured on the Event log page.
To Next Page
Loading...
Need help?
General
