Leica GR30 - Related Topics; Status Tracking: GLONASS; Field Description

6: Context sensitive help
65
Not available
Lists the PRN numbers of the unavailable satellites. The satellites are not available in the almanac.
To enable or disable the automatic update of the status page, please go to Receiver setup: Web server and
activate or deactivate the Automatic status page reload.
If the health status of a satellite is changed by a user and is different to what is sent in the broadcast
ephemeris, this satellite is shown in brackets. Go to GNSS management: Tracking to change the health
status of a satellite.
Related topics
Tracking: General
Tracking: GLONASS
Tracking: GALILEO
Tracking: SBAS
Tracking: BEIDOU
Tracking: QZSS
GNSS management: Tracking
Status tracking: GLONASS
Field Description
The table below describes the fields in the Status: GLONASS tab.
The information shown is dependent on the settings configured on the GNSS management: Tracking page and which satellite options
are available on the receiver.
Press the Refresh icon to update the displayed data.
Field
Description
Sat
The Slot number of the satellite.
Elevation
The elevation of the satellite in degrees. An arrow is shown to indicate if the satellite is rising or setting.
Azimuth
The azimuth of the satellite in degrees.
S/N L1
The signal to noise ratio on L1. The number is shown in brackets if the signal is not currently being
used in the position calculations.
S/N L2P
The signal to noise ratio on L2P. The number is shown in brackets if the signal is not currently being
used in the position calculations.
S/N L2C
The signal to noise ratio on L2C. The number is shown in brackets if the signal is not currently being
used in the position calculations.
Health
Description
Healthy
Lists the Slot number of the healthy satellites.
Bad
Lists the Slot number of the unhealthy satellites. The satellites are available in the almanac but are
flagged unhealthy.
Not available
Lists the Slot number of the unavailable satellites. The satellites are not available in the almanac.
To enable or disable the automatic update of the status page, please go to Receiver setup: Web server and
activate or deactivate the Automatic status page reload.
If the health status of a satellite is changed by a user and is different to what is sent in the broadcast
ephemeris, this satellite is shown in brackets. Go to GNSS management: Tracking to change the health
status of a satellite.
Related topics