Leica GR30 - Button Combinations

22
Button combinations
Function
Activate dual button functionality
Press and hold both buttons until all LEDs are flashing. After 1 s the Raw data logging LED starts flashing slowly.
The following instrument commands are now activated.
Start/Stop all logging sessions
Activate dual button functionality as described above.
If all logging sessions had been off, the Raw data logging LED is flashing green.
•
Press the Function button until the LED flashes quickly to START all configured logging sessions if the Raw data
logging LED is flashing green.
OR
If any logging session had been active, the Raw data logging LED is flashing red.
• Press the Function button until the LED flashes quickly to STOP all active logging sessions if the Raw data logging
LED is flashing red.
After logging has been started or stopped, the LED and instrument functionality goes
back to general behaviour.
Start/Stop all data streams
Activate dual button functionality as described above.
Press the Function button until the RT out data streams LED starts flashing slowly:
If all data streams had been off, the RT out data stream LED is flashing green.
•
Press the Function button until the LED flashes quickly to START all configured data streams if the RT out data
steam LED is flashing green.
OR
If any data stream had been active, the RT out data stream LED is flashing red.
• Press the Function button until the LED flashes quickly to STOP all active data streams if the RT out data stream
LED is flashing red.
After data streams have been started or stopped, the LED and instrument functionality
goes back to general behaviour.
Initialise the measurement engine
Activate dual button functionality as described above.
Press the Function button until the Position LED starts flashing slowly:
•
Press the Function button for until the LED flashes quickly to reset the measurement engine. This will delete all
almanac and ephemeris information and the instrument will take a few minutes to restart tracking satellites.
After the measurement engine has been initialised, the LED and instrument functionality goes back to general behaviour.
Format the receiver settings
Activate dual button functionality as described above.
Press the Function button until the Power LED starts flashing slowly:
•
Press the Function button until the LED flashes quickly to set all configured instrument settings back to factory
default values.
After the system format is completed, the LED and instrument functionality goes back to general behaviour.