Leica GR30 - Logging Session Wizard: Compact RINEX (Hatanaka); Setting Descriptions

6: Context sensitive help
125
abcdefghijklmnopqrstuvwxyz
- _ and a "space" are allowed.
• If left empty, the field in the RINEX header will be left blank.
Agency
Enter the name of the agency that is to appear in the RINEX file header.
• Maximum number of characters allowed is 40.
• Only certain ASCII characters are allowed.
0123456789
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
- _ and a "space" are allowed.
• If left empty, the field in the RINEX header will be left blank.
Include SNR values
Activate to include the (unmapped) SNR observations in the RINEX file.
Log doppler observations
Activate to include the doppler observations in the RINEX file.
Mixed navigation file
Activate to write a single navigation file for all tracked satellite systems instead of writing
separate navigation files for each satellite system.
When changing the logging rate of a high rate logging session, the session must first be deactivated. After
changing the rate the session can be reactivated and will then use the new rate.
Example: A 20 Hz MDB logging session should be changed into a 50 Hz MDB session.
Press to go back to the previous wizard step. Press to continue to the next wizard step.
Press to cancel and return to GNSS management: Logging session.
Logging session wizard: Compact RINEX (Hatanaka)
Setting Descriptions
The table below describes the settings that can be configured on the Compact RINEX (Hatanaka) page.
Setting
Description
Logging rate
Select the rate at which the observations are to be logged.
Note: A faster logging rate results in higher resource consumption on the receiver.
Length of file
Choose a value from 5 minutes to 24 hours.
The file length defines how long data is written to one file before a new file is created.
Dynamics
Raw data for the Compact RINEX logging session can be logged in static or moving
(kinematic) mode.
Operator
Enter the name of the operator that is to appear in the RINEX file header.
• Maximum number of characters allowed is 20.
• Only certain ASCII characters are allowed.
0123456789
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
- _ and a "space" are allowed.
• If left empty, the field in the RINEX header will be left blank.