78
Receiver setup: Event log
Status: Network connections
Background information
Displays all active network connections used to connect the receiver to a network, including DynDNS setup if configured.
Possible connections
• Ethernet
• Mobile Internet
• WLAN
• TCP/IP over USB
• DynDNS
• Bluetooth
Field Descriptions
The table below describes the fields in the Status: Network connections page.
Default gateway shown in the status header indicates if the specific connection is set as the main gateway.
Press the Refresh icon to update the displayed data.
The status of the configured Ethernet connection, Connected or Disconnected.
The hostname for receiver access in a DHCP network.
Indicates if the IP address was assigned by DHCP or manually configured.
The IP address used for accessing the receiver via Ethernet connection.
The subnet mask for the connection.
The gateway for the connection.
The IP addresses of the DNS servers that are used.
The amount of data sent out from this connection.
The amount of data received by this connection.
The MAC address of the receivers Ethernet device.
The status of the configured network connection, Connected or Disconnected.
The duration or uptime of this connection without interruption.
Indicates if the IP address was assigned by DHCP or manually configured.
The current IP address of the connection.
The subnet mask for the connection.
The amount of data sent out from this connection.
The amount of data received by this connection.
The name of the mobile Internet device used for this connection.
The version of the firmware installed on the attached mobile internet device.
The port used for connecting the mobile Internet device.
The status of the configured WLAN connection, Not used, Connecting or Connected.
The hostname for receiver access in a DHCP network.
Indicates if the IP address was assigned by DHCP or manually configured.
The IP address used for accessing the receiver via WLAN connection.
The subnet mask for the connection.
The gateway for the connection.
To Next Page
