68
Lists the PRN numbers of the unavailable satellites. The satellites are not available in the almanac.
To enable or disable the automatic update of the status page, please go to Receiver setup: Web server and
activate or deactivate the Automatic status page reload.
Related topics
Tracking: General
Tracking:GPS
Tracking: GLONASS
Tracking: GALILEO
Tracking: SBAS
Tracking: QZSS
GNSS management: Tracking
Status tracking: QZSS
Field Description
The table below describes the fields in the Status: QZSS tab.
The information shown is dependent on the settings configured on the GNSS management: Tracking page and which satellite options
are available on the receiver.
Press the Refresh icon to update the displayed data.
The Pseudo Random Noise (PRN) number of the satellite.
The elevation of the satellite in degrees. An arrow is shown to indicate if the satellite is rising or
setting.
The azimuth of the satellite in degrees.
The signal to noise ratio on L1. The number is shown in brackets if the signal is not currently being
used in the position calculations.
The signal to noise ratio on L2C. The number is shown in brackets if the signal is not currently being
used in the position calculations.
The signal to noise ratio on L5. The number is shown in brackets if the signal is not currently being
used in the position calculations.
Lists the PRN numbers of the healthy satellites.
Lists the PRN numbers of the unhealthy satellites. The satellites are available in the almanac but are
flagged unhealthy.
Lists the PRN numbers of the unavailable satellites. The satellites are not available in the almanac.
To enable or disable the automatic update of the status page, please go to Receiver setup: Web server and
activate or deactivate the Automatic status page reload.
Related topics
Tracking: General
Tracking:GPS
Tracking: GLONASS
Tracking: GALILEO
Tracking: SBAS
To Next Page
Loading...
