104
Outgoing data stream wizard: Set streaming status
Setting Descriptions
The table below describes the settings that can be configured on the Set streaming status page.
Deactivate the data stream if you do not want it to run immediately.
Press to go back to the previous wizard step.
Press to cancel and return to GNSS management: Outgoing data stream.
GNSS management: Incoming data streams
GNSS management: Incoming data streams
Background Information
This page provides an overview of the configured incoming data streams.
Configure incoming meteo or tilt data or use an incoming real time data stream to monitor the receiver's position,
Create a new incoming data stream by pressing Create new data stream .
The maximum number of meteo, tilt and real time data streams is one of each type.
Mozillia Firefox does not support the use of certain ports. Use a different internet browser if these ports
need to be used. Ports blocked by default in Mozilla Firefox browser.
An incoming real time data stream can only be activated if GPS and GLO tracking of L2C signals is
disabled.
If you want to activate an incoming real time data stream make sure to first disable the tracking of GPS
and GLO L2C signals.
For single site corrections, a fixed RTK solution is only available for baselines up to 80km. Beyond 80km a
DGPS solution is provided.
Fixed RTK solutions for baselines longer than 80km are available when using Network Corrections.
Setting Descriptions
The table below describes the fields in the Incoming data streams tab.
To activate or deactivate a data stream press the Activate icon.
The configured incoming correction data type.
The configured incoming message type.
The configured connection type, e.g TCP/IP or Ntrip.
To Next Page
Loading...
