124
Press to go back to the previous wizard step. Press to continue to the next wizard step.
Press to cancel and return to GNSS management: Logging session.
Related topics
GNSS management / Site name and coordinates
Logging session wizard: MDB
Setting Descriptions
The table below describes the settings that can be configured on the MDB page.
Select the rate at which the observations are to be logged.
Note: a faster logging rate results in higher resource consumption on the receiver.
Choose a value from 5 minutes to 24 hours.
The file length defines how long data is written to one file before a new file is created.
Raw data for the MDB logging session can be logged in static or moving (kinematic)
mode.
Activate or deactivate logging doppler observations to the MDB file.
When changing the logging rate of a high rate logging session, the session must first be deactivated. After
changing the rate the session can be reactivated and will then use the new rate.
Example: A 20 Hz MDB logging session should be changed into a 50 Hz MDB session.
Press to go back to the previous wizard step. Press to continue to the next wizard step.
Press to cancel and return to GNSS management: Logging session.
Logging session wizard: RINEX
Setting Descriptions
The table below describes the settings that can be configured on the RINEX page.
Select the rate at which the observations are to be logged.
Note: A faster logging rate results in higher resource consumption on the receiver.
Choose a value from 5 minutes to 24 hours.
The file length defines how long data is written to one file before a new file is created.
Raw data for the RINEX logging session can be logged in static or moving (kinematic)
mode.
Enter the name of the operator that is to appear in the RINEX file header.
• Maximum number of characters allowed is 20.
• Only certain ASCII characters are allowed.
0123456789
ABCDEFGHIJKLMNOPQRSTUVWXYZ
To Next Page
Loading...
