Leica GR30 - Network Connections; Network Connections: Overview

142
Configure all receiver related settings such as network connections, FTP push locations and the user management. Or use the tools to
upgrade the receiver firmware, add new option keys or switch to your preferred language.
Menu option
Description
Network Connections
•
Configure the receiver IP and DNS settings to allow access via the
Internet.
• Selected devices such as mobile phones, modems and radios that can
be used for mobile Internet access to the receiver.
• Activate the Bluetooth device to allow access to the web interface via
Bluetooth PAN connection or to a data stream via Bluetooth serial
connection.
OR
Activate the WLAN adapter and configure WLAN profiles to access the
receiver with WLAN capable devices or stream data using a WLAN
connection.
Access Management
Create new users and set the access level for the receivers web interface.
Spider and remote access
Configure and open remote access connections for OWI based software, such as
GNSS Spider to the receiver.
Ntrip Caster
Activate or deactivate the Ntrip caster, define the settings for the port it runs on and
view the configuation of mount points and data types.
Web server
Set the HTTP port number or configure secure access to the web interface via an
SSL (Secure Socket Layer) connection.
DynDNS
Allow access to the receivers web interface when using a dynamic IP address by
configuring and enabling the DynDNS functionality.
FTP server
Configure access to the receivers FTP server (SD card).
Device management
Create, configure or delete modem, radio and GSM devices to be used with the
receiver.
Event log
Activate the sending of event emails that contain the event log information.
Set the auto delete interval for all event log entries.
Power management
Configure the power up and low power behaviour of the receiver according to the
intended use case.
SNMP
Enable Simple Network Management Protocol to monitor the GR/GM receiver for
conditions that warrant administrative attention.
Tools
Load new firmware or purchased options to the receiver, change the language or
use the tools to format or reboot the receiver.
Network connections
Network connections: Overview
The Network connections pages allow defining the access to the receiver via different communication options.
Tab option
Description
General
Specify the receiver's hostname, define internet gateway priorities and activate backup
communication.
Ethernet
Configure the Ethernet settings which will enable the receiver to be accessed via the internet.
Mobile internet
Configure access to the receiver via the internet with a mobile phone device (e.g.GSM).
Bluetooth
Configure access to the receiver via a wireless Bluetooth connection.
Only on GR25 receivers fitted with a Bluetooth radio.
WLAN
Configure access to the receiver via a wireless LAN connection.
Only on GR25 receivers fitted with a WLAN radio.