116
Background Information
This mode allows the receiver to receive data on a physical serial port.
This page allows the user to change the settings on the instrument's serial port.
Setting Descriptions
The table below describes the settings that can be configured on the Configure serial port page.
Only available on GR25/50. Select the physical serial port for data transmission
• Serial port 1
• Serial port 2
For the GR10/30 & GM10/30, Serial port 1 is configured
automatically as there is only one serial port available.
Baud rate, Parity, Data
bits, Stop bits
Select the port settings for the communication between the receiver and the serial port.
Defines which kind of handshake is used.
• None: No handshake.
• RTS/CTS: Handshake in both directions.
Press to go back to the previous wizard step. Press to continue to the next wizard step.
Press to cancel and return to GNSS management: Incoming data streams.
Incoming data stream wizard: Set streaming status
Background Information
An incoming real time data stream can only be activated if GPS and GLO tracking of L2C signals is
disabled.
If you want to activate an incoming real time data stream make sure to first disable the tracking of GPS
and GLO L2C signals.
Setting Descriptions
The table below describes the settings that can be configured on the Set streaming status page.
Deactivate the data stream if you do not want it to run immediately.
Press to store the data stream configuration.
Press to go back to the previous wizard step.
Press to cancel and return to GNSS management: Incoming data stream.
To Next Page
