Leica GR30 - Background Information; Logging Session Wizard: Session Timing; Related Topics

122
•
RINEX
• Compact RINEX (Hatanaka)
• NMEA
Session priority
Select the priority level to be used for Smart clean-up of the SD card, either high,
medium or low.
If Smart clean-up is activated then the session priority will determine which
logging sessions are stopped / saved if the SD card is nearing full capacity.
Read the topic GNSS management: Smart clean-up
, for further information on the
Smart clean-up functionality .
Session type
Select the session type, either continuous or timed.
• Timed: Allows specific times to be configured for the session to log data,
including duration, repetition interval and the number of intervals.
Selecting timed will open an additional wizard step, Session timing.
Do not change a logging session created by Leica
GNSS Spider into a timed logging session. Spider
cannot configure timed logging sessions.
• Continuous: Select to define the data type file length only.
If a continuous session type is activated, it will start logging immediately.
To stop logging, manually deactivate the session via the GNSS
management: Logging sessions menu option.
Press to continue to the next wizard step.
Press to cancel and return to GNSS management: Logging session.
Related topics
Logging sessions: Overview
GNSS management: Logging sessions
GNSS management: Smart clean-up
Logging session wizard: Session timing
Background information
Timed logging sessions consider the configured file length and the configured interval length.
Example: If a timed logging session is configured to
• Start logging at a certain date at 15:00h
• End logging after 30min
• No of repeats: repeat 10 times
• Start next session: 10min after last session ended
• And the file length is set to 1h, the behaviour will be as follows: