2: Description of the system
13
Software upload
All software is stored in the System RAM of the instrument.
A new firmware file must be uploaded to the SD card before installation. The file can be
uploaded via:
• the Web interface.
• direct copy to the SD card using a computer.
• direct FTP access to the SD card.
After uploading, the firmware must be transferred from the SD card to the System RAM via
the Web interface. For detailed step-by-step instructions, refer to Firmware upgrade step-by-
step.
Leica GNSS Spider can also be used to install the firmware. Loading the firmware to the SD
card and installing it on the instrument is done in one step when using GNSS Spider. Refer
to the Leica GNSS Spider Online Help for more information.
Receiver Information
Important information regarding the instrument details, installed options and firmware can be found on the Status / Receiver
Information page on the Web interface.
Related topics
Is my firmware up to date?
Firmware upgrade step-by-step
Firmware upgrade using Leica GNSS Spider
Loading a Language file
Status: Receiver Information
Receiver setup: Firmware management
Receiver setup: Language management
Power Supply
General
Use the Leica Geosystems power supplies, batteries, chargers and accessories or accessories recommended by Leica Geosystems to
ensure the correct functionality of the instrument.
Power options
Power for the instrument can be supplied either by power supply or batteries.
Up to two external power supplies can be connected using a Y-cable.
For the GR25/50 only, GEB241 (754834) battery for internal power supply. Battery can be
charged from an external power source.
To Next Page
Loading...
