6: Context sensitive help
63
quality
Height quality of the computed position.
To enable or disable the automatic update of the status page, please go to Receiver setup: Web server and
activate or deactivate the Automatic status page reload.
Related topics
Status: Overview
GNSS management: Site name and coordinates
Status: Tracking
Status tracking: General
Field Description
The table below describes the fields in the Status: General tab.
The information shown is dependent on the settings configured on the GNSS management: Tracking page
and which satellite options are available on the receiver.
If the satellite health setting has been changed to a user defined setting in the GNSS management: Tracking
page, then the satellite PRN will be displayed in brackets to indicate that this is not the almanac transmitted
health status for that satellite.
Press the Refresh icon to update the displayed data.
The date and time of the GPS almanac.
The date and time of the GLONASS almanac.
Only available for receivers with the GLONASS option.
The date and time of the GALILEO almanac.
Only available for receivers with the GALILEO option.
The date and time of the BeiDou almanac.
Only available for receivers with the BeiDou option.
The date and time of the QZSS almanac.
Only available for receivers with QZSS option.
Shows the oscillator configured on the receiver. If no external oscillator is used, Internal
clock is shown.
If an external oscillator is configured with the oscillator fallback option active and no time
signal was detected for more than 5 minutes or the antenna was disconnected for more
than 5 minutes, the receiver starts using the internal clock instead of the selected external
oscillator.
A warning message will be shown in this field that a fallback to internal oscillator occurred.
If an external oscillator is selected but not connected, the
receiver will not track any satellite signals.
To Next Page
