Leica GR30 - Page 54

4: User Interface
29
¦
¦----------- Site Config
Select to edit site code, antenna type and antenna height.
¦ ¦------- Site code
¦ ¦------- Antenna type
¦ ¦------- Antenna height
¦
¦----------- Logging sessions
¦ ¦
Select to activate or deactivate configured logging
sessions. Use right and left buttons to activate or
deactivate a session.
¦ ¦------- Overveiw page
¦ ¦------- List of configured sessions
¦
¦----------- Data streams
¦ ¦
Select to activate or deactivate all configured data streams.
Use right and left buttons to activate or deactivate all
sessions.
¦ ¦------- Overveiw page
¦ ¦------- Activate/Deactivate All
¦
¦----------- Network Config (Bluetooth receivers)
¦ ¦
¦ ¦
Edit the GR25/50 hostname. This is also the Bluetooth
name. Edit the Ethernet settings (DHCP on/off, IP address,
subnet mask, gateway) or enable/disable the Bluetooth
device.
¦ ¦------- Ethernet
¦ ¦ ¦------- Hostname
¦ ¦ ¦------- DHCP
¦ ¦ ¦------- IP address
¦ ¦ ¦------- Subnet
¦ ¦ ¦------- Gateway
¦ ¦------- Bluetooth
¦
¦----------- Network Config (WLAN receivers)
¦ ¦
Edit the GR25/50 hostname, the Ethernet settings (DHCP
on/off, IP address, subnet mask, gateway) or the WLAN
settings.
¦ ¦------- Ethernet
¦ ¦ ¦------- Hostname
¦ ¦ ¦------- DHCP
¦ ¦ ¦------- IP address
¦ ¦ ¦------- Subnet
¦ ¦ ¦------- Gateway
¦ ¦------- WLAN
¦ ¦------- WLAN radio
¦ ¦------- WLAN profiles
¦
¦----------- Maintenance
¦
¦
Format the receiver configuration, SD card or attached
USB storage device or stop the USB storage device to
remove. Initialize the ME. Use the up or down button to
switch between the maintenance functions.
¦------- Format SD card
¦------- Format USB device
¦------- Format System