100
Preconditions:
Control is set on the basis of the instal-
led nozzles and the corresponding do-
sing table.
The intended travel speed (km/h) and
spray rate (l/ha) are known.
The required spray pressure is deter-
mined.
Switch the selection valve of the spray
pump (A) to change-over valve (C).
Place the switchover valve (C) on the
clean water tank.
In the control: Manual mode for control-
ling the distribution rate.
The work mask view changes.
To close the control valve: Press and
hold softkey for 10 seconds.
To open the control valve slightly: Press
and hold softkey for 3 seconds.
On the tractor: Switch on pump via PTO
shaft.
Operate pump at 400 rpm.
To Next Page
Loading...
