LEMKEN Primus 10 - Apply Spraying Agent

Operation
113
6.12.2 Apply spraying agent
 Bring the tractor-device combination into
position.
 Spraying:
 Move over the processing area with
the tractor-device combination.
 Switch on the nozzles.
 During distribution, drive at a speed
that matches the installed nozzles and
the distribution rate set.
 To avoid the spraying agent drifting: First
spray the outer perimeter of the property
with drift-free nozzles.
 Use low drift nozzles or boundary
nozzles.or
 Switch off any outer nozzles.
 Then spray the inside of the spray lanes
with application-specific nozzles.
 Monitor and, if necessary, adjust distri-
bution rate, pressure and forward speed.
 Monitor the level of the main tank on the
indirect level indicator.
 At the end of the spray lane, switch off
the nozzles and turn them around.
 Continue distribution in the next row.
 If the edge of the cultivated area runs
diagonal to the cultivated area, turn off
outer nozzles or part-width sections.