LEMKEN Primus 10 - Standard Procedure; Suction Filter

Cleaning
139
7.5.1 Standard procedure
 To remove particles of dirt from the sys-
tem: Close flushing valve before the final
day of spraying.
 Check whether the pump is switched off
via the PTO shaft.
 Place a collection tray (1) under the filter
before cleaning.
 Clean the suction filter.
 Clean the pressure filter.
 Return the flush valve to its original posi-
tion.
7.5.2 Suction filter
Prerequisite: The filling connection is
closed with a sealing cap.
 Remove the seal (1).
 Loosen (3) union nut.
 Remove the suction filter (2).
 Clean the individual components of the
suction filter with water and a soft brush.
 Install (2) suction filter.
1
3
1
2