LEMKEN Primus 10 - Traction Loops; Axles

Technical data
181
Depending on the equipment, the connec-
ting fixture can be unscrewed and installed
higher to adapt to the implement on the
tractor. When doing so, only permissible
traction loops may be used.
The drawbar extension is provided to
enlarge the clearance between the tractor
and the implement.
To prevent damage to the implement or
the tractor, a drawbar extension is required
for the following sprayer booms:
B 30/FS 24 to B 30/FS 30.
When using other sprayer booms, if there
is a risk of damage to the implement or to
the tractor, then a drawbar extension is al-
so required for these sprayer booms.
10.4 Traction loops
Only LEMKEN-approved traction loops may be used.
Traction loops must satisfy the following minimum technical requirements:
Drawbar load [kg]:
2000
D-value [kN]:
56.32
Maximum speed [km/h]:
60
10.5 Axles
 Observe the applicable national regulations.
The maximum permissible speed may be 25 or 40 Km/h, depending on the load
bearing capacity of the wheels.
Maximum permissible speed
 Running axle: 25 Km/h