• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Remove the front riser cage, see
“Remove the front riser cage” on page 110.
Step 2. Separate the low-profile riser cage from the full-height riser cage.
Figure 104. Separating the two cages
a. Loosen the screw that secures the low-profile cage to a full-height one.
b.
Tilt the cage and lift it out.
Step 3. Remove the PCIe adapter from the riser cage.
Figure 105. Removing the PCIe adapter
Chapter 5. Hardware replacement procedures 113
To Next Page
Loading...
