Figure 6. Rear view with one low profile and one full height PCIe adapter
Table 13. Components on the rear of the server
Callout Callout
1 Power supply unit 1
2 PCIe slot 1 on riser 1 assembly
3 PCIe slot 2 on riser 1 assembly 4 System ID LED
5 System error LED
6 RoT fault LED
7 Rear M.2 assembly 8 Power supply unit 2
9 Ethernet connectors on rear OCP module 2 (optional) 10 XCC system management port (10/100/1000 Mbps
RJ-45)
11 USB 3.2 Gen 1 (5Gbps) connectors (3 DCIs) 12 VGA connector
13 Ethernet connectors on rear OCP module 1 (optional)
Note: For more information about each component, see
“Rear components overview” on page 27.
Server model with two 2.5-inch hot-swap rear drive bays and one PCIe slot
The following illustration shows the rear view of the server model with two hot-swap drive bays and one PCIe
slot. Depending on the model, your server might look slightly different from the illustration below.
Figure 7. Rear view with one full height PCIe adapter
Table 14. Components on the rear of the server
1 Power supply unit 1
2 PCIe slot 1 on riser 1 assembly
3 Rear 2.5-inch drive bays (2) 4 System ID LED
5 System error LED
6 RoT fault LED
7 Power supply unit 2
8 Ethernet connectors on rear OCP module 2 (optional)
9 XCC system management port (10/100/1000 Mbps RJ-
45)
10 USB 3.2 Gen 1 (5Gbps) connectors (3 DCIs)
11 VGA connector 12 Ethernet connectors on rear OCP module 1 (optional)
Note: For more information about each component, see
“Rear components overview” on page 27.
Chapter 2. Server components 25
To Next Page
Loading...
