Figure 63. Installing front mounting pins
a. Slide the inner rail all the way in to allow the front latch to open.
b.
Open the front latch and align the mounting pins with corresponding front mounting
flanges.
c.
Pull the rail forward until the mounting pins go through the holes.
d.
Release the front latch to secure the rail to the rack.
Step 3. Make sure that the rail is securely engaged in the flange holes by inspecting that the hook has
caught and by sliding back and forward to ensure the rail does not pop out.
Important: Make sure both ends of the rail are seated at the same height.
Step 4. Repeat Step 1 on page 78 to Step 3 on page 79 to install the other rail.
Step 5. Install the server to the rack, see
“Install the server to the rack (friction rails)” on page 85.
Install the rails to the rack (slide rail)
Follow instructions in this section to install ThinkSystem Toolless Slide Rail Kit V4 and ThinkSystem
Advanced Toolless Slide Rail Kit V4 to the rack.
S036
Chapter 5. Hardware replacement procedures 79
To Next Page
Loading...
