Diagnostic aids 3-9
5060-4xx
ITU Count Value
This is the page count of the current ITU. It cannot be reset unless a new ITU is installed.
Press Select to view the count value.
Fuser Cnt Value
Enter the Configuration Menu and select Fuser Cnt Value.
The value can be reset in Reset Fuser Cnt.
This only displays if the Maintenance Warning and Intervention function is enabled in the printer Configuration
ID. The fuser maintenance page counter is incremented when a page is printed and incremented by two when a
duplex sheet is printed. The counter can be used to track printer usage. When the counter reaches 200,000, the
printer posts a fuser maintenance message on the operator panel.
Reset Fuser Cnt
This only displays if the Maintenance Warning and Intervention function is enabled in the printer Configuration
ID. The fuser maintenance page counter is incremented when a page is printed and incremented by two when a
duplex sheet is printed. The counter can be used to track printer usage. When the counter reaches 200,000, the
printer posts a fuser maintenance message on the operator panel.
1. Select Reset Fuser Cnt in the Config Menu to view the page count.
2. Press Return to return to the previous menu or press Select to reset the maintenance page counter back
to zero.
Prt Quality Pgs
The Print Quality Test consists of five pages. Pages one and two contain a mixture of graphics and text. The
remainder of the pages only contain graphics. Use this test to identify print quality problems. The Test Pages
must be printed on A4, Legal or Letter paper.
1. Select Prt Quality Pgs from the Config Menu.
2. Press Select.
Go to “Print tests” on appendix page B-3 for representative samples of the pages.
Color Trapping
Color trapping is an aid to graphic and text. When a text or graphics appear over other colors, a misalignment
may allow white paper to show through at the borders of the colors. Color trapping reduces the cutout area
under the upper image so a slight misalignment does not show.This only affects PostScript printing.
1. Select Color Trapping from the Config Menu
2. Select the value or Off. The range is 1 to 5 and the default value is 2.
Use Menu to increase the value.
Tray Insert Msg
This setting controls how long, in seconds, the tray insert message displays when a tray is inserted.
The values are Disabled and 1 to 90. The default value is 5.
To Next Page
Loading...
