3-28 Service Manual
5060-4xx
FINISHER TESTS
Staple Test
This test verifies the operation of the staple mechanism in the finisher.
To run the Staple Test:
Select Staple Test from FINISHER TESTS in the Diagnostics menu. The printer feeds eight pieces of media to
the finisher and accumulates all eight pieces in the accumulator. After the last sheet is accumulated, the pack is
stapled.
When the test is complete, the printer returns to the original screen.
Finisher Feed Test
This test verifies that media can be fed to the finisher output bin.
To run the Finisher Feed Test, select Finisher Feed Test from the menu. The printer feeds eight pieces of media
to the finisher output bin.
Note: The sheets fed for this test are blank.
This test cannot be canceled or terminated once the test has begun. When the test is complete the printer
returns to the original screen.
Finisher Sensor Test
This test determines if the finisher sensors are working correctly.
To run this test:
1. Select Finisher Sensor Test from FINISHER TESTS in the Diagnostics mode.
• If you Select Media 1 from the menu the following is displayed and the sensors polled:
Once the sensors are polled, the following is displayed and the sensors are ready to test:
Once this screen is displayed you can manually actuate each of the sensors. When the sensor is
closed, CL is displayed, when the sensor is open OP is displayed.
Media Path 1
testing............
Media Path 1
S1=OP S2=OP
S1 =Punch Timing Sensor A
S2 =Punch Timing Sensor B
To Next Page
Loading...
