General information 1-9
5060-4xx
Available memory options
Optional 64MB, 128MB, 256MB and 512MB SDRAM DIMMs are available from Lexmark. The memory options
are 168-pin synchronous DRAM DIMMs (dual in-line memory modules) meeting or exceeding the following
specifications:
• 100MHz or greater
• 4KB refresh rate
• Unbuffered, non ECC
• x32
• 3.3 V
Unpredictable results may occur if an attempt is made to operate the printer with memory other than SDRAM
DIMM memory with the stated specifications.
Flash Memory Options 16, 32 (Nand Flash)
Expansion
• Memory slot for extra flash or DRAM
• Expansion slot for optional interface cards
• Code expansion slot (application solution firmware cards)
• On-board hard disk interface (for optional hard disk)
Additional memory may be required for printing complex pages or full-page, high-resolution images in 1200
image quality at rated speeds.
To Next Page
Loading...
