3-26 Service Manual
5060-4xx
For 2000-sheet trays
This test can also be used to determine if the 2000-sheet tray sensors are working correctly.
1. Select Sensor Test from INPUT TRAY TESTS in the Diagnostics mode. for the tray you want to test.
The following is displayed:
The selected tray is displayed on line 1 <input tray> is either Tray 2, Tray 3, or Tray 4.
2. Manually actuate each tray sensor by moving the flag in and out of the sensor. OP (Open) appears when
the flag is out of the sensor, or CL (Closed) when the flag is in the sensor.
OUTPUT BIN TESTS
Feed Test
Feed to all Bins (if multiple bins are attached)
Sensor Test
Diverter Test (if 5-Bin mailbox is installed)
Feed Test
Note: If the “Configure Bins” printer setting is link rather than mailbox, the printer selects its own internal bin
linking regardless of which output bin is selected for the feed test.
This test verifies that media can be fed to a specific output bin. No information is printed on the media because
the printhead is not turned on during this test.
To run the Output Bin Feed Test:
1. Select Feed Test from OUTPUT BIN TESTS in the Diagnostics mode.
2. Select the output bin you want the paper to exit into. All output bins installed on the printer are shown on
the feed test menu.
3. Select either Single (one sheet of media feeds to the selected output bin) or Continuous (media continues
feeding to the selected output bin) until Return or Stop is pressed.
4. Press Return or Stop to exit the test.
Feed to All Bins
One page is fed to every bin, including the finisher, if available. The test runs continuously until Return or Stop
is pressed.
<input tray> EM=OP
NE=OP LE=OP SC=OP
EM =trays empty sensor
NE =trays near empty sensor
LE =trays paper level sensor
SC =input trays side cover sensor
To Next Page
Loading...
