2-52 Service Manual
5060-4xx
132 error code
Cold hot roll
Step Action and questions Yes No
1 Measure the voltage on connector J33-11 on the
system board. The voltage should measure
approximately +0.13 V dc to +0.64 V dc as the hot roll
lamp turns off and on.
Is the voltage correct?
Go to step 2 Replace the
“System board”
on page 4-72
2
Remove the fuser from the printer. Check continuity of
the hot roll lamp by measuring between pins 1 and 2 on
the AC fuser connector on the fuser assembly.
Is there continuity?
Go to step 4 Go to step 3
3
Check to make sure the hot roll lamp is installed
correctly.
Is the hot roll lamp installed correctly?
Go to step 4 Install the lamp
correctly. If this
does not fix the
problem, replace
the “Fuser
assembly” on
page 4-35.
4
Reinstall the fuser assembly. Watch to see if the lamps
turn on and off as the lamp heats up.
Do the lamps turn on?
Go to step 5 Replace the
“Fuser
assembly” on
page 4-35
5
Turn the printer on and allow it to reach a Ready
prompt.
Note: The printer may not complete POR and may
continue to display the error code.
Remove the fuser from the printer. Measure the voltage
on connector J33-6 on the system board. The voltage
should measure approximately 3.3 V dc.
Is the voltage correct?
Go to step 6 Replace the
“System board”
on page 4-72.
6
Measure the voltage on the fuser DC control connector
on the LVPS. Measure the voltage on pin 6 of the
connect.
Does the voltage measure approximately +3.3 V dc?
Replace the
“Fuser
assembly” on
page 4-35.
Replace the
“LVPS
assembly” on
page 4-46.
To Next Page
Loading...
