3-10 Service Manual
5060-4xx
SIZE SENSING
Automatic size sensing can be disabled or enabled in this menu. Only paper sources that support Auto Size
Sensing are displayed.
1. Select SIZE SENSING from the Config Menu.
2. Select a tray. Only those trays with size sensing display. One of the following is displayed:
Tray 1 Sensing
Tray 2 Sensing
Tray 3 Sensing
Tray 4 Sensing
3. Select Auto to turn size sensing on for that tray, or select Off to disable size sensing.
4. Select Return to exit.
Panel Menus
Disabling Panel Menus prohibits users from modifying any setting or executing any operation available in the
Ready Menu group.
1. Select Panel Menus from the Config Menu.
2. Select Disable or Enable.
Enable is the default.
PPDS Emulation
This only displays if the PPDS interpreter is available.
1. Select PPDS Emulation from the Config Menu.
2. Select Activate or Deactivate.
Demo Mode
This printer supports a demo mode that is usually used in retail environments to illustrate the features of the
printer. The printer features are illustrated by demonstration files stored in the RIP firmware, flash option, or disk
option.
1. Select Demo Mode from the Config Menu.
2. Select Activate or Deactivate.
Deactivate is the default value.
Factory Defaults
The customer can restore either the network settings or the base printer settings to their factory default values.
When Restore Base is selected, non-critical base printer NVRAM settings are restored. When Restore Network
is selected, all network NVRAM settings are restored to their factory default settings. This option is only available
on models with an integrated network adapter. In either case, Restoring Factory Defaults is displayed after the
operation is selected.
1. Select Factory Defaults from the Config Menu.
2. Select Restore Base or Restore Network.
Note: Restore Network is only listed on models that have integrated network support.
To Next Page
Loading...
