4-46 Service Manual
5060-4xx
LVPS assembly
Go to “LVPS, 115V/230V switchable” on page 7-31 for part number.
Note: Set the voltage range switch to the proper power setting for the geographic area you are in.
1. Remove the fuser drive assembly. See “Fuser drive assembly” on page 4-37.
2. Remove the rear cover. See “Rear cover” on page 4-16.
3. Disconnect the J33 and J35 cables from the system board.
4. Remove the four LVPS screws (A) type “121” on page 4-2 from the rear of the printer.
5. Remove the right rear cover screw (B) type “121” on page 4-2.
To Next Page
Loading...
