Diagnostic aids 3-33
5060-4xx
Viewing the permanent page count
The permanent page count can only be viewed from the operator panel and cannot be changed.
1. Select Perm Page Count from PRINTER SETUP in the Diagnostics mode.
2. A screen similar to the following screen displays when permanent page count is selected:
3. Press Return to return to PRINTER SETUP in the Diagnostics mode.
Serial Number
You can view the serial number.
Engine Setting x
Warning: Should not be changed without specific instructions from the next level support.
Model Name
You can view the model name.
Configuration ID
Warning: Should not be changed without specific instructions from the next level support.
The configuration ID is used to communicate characteristics of certain areas of the printer that cannot be
determined by hardware sensors. The configuration ID is originally set when the printer is manufactured.
However, it needs to be reset when the system board or paper size sensing board are replaced.
1. Select Configuration ID from PRINTER SETUP in the Diagnostics mode.
The following screen is displayed:
2. Open the waste container door to locate a label above the waste container. The label contains the
configuration ID.
3. The leftmost digit blinks, indicating it is the first digit to be changed. To change the value, press Menu until
the desired value is displayed. Press Select to move to the next digit. The digit blinks. Continue modifying
each digit using this method. To skip a digit, and keep its current value, press Select.
4. When Select is pressed after the final digit, the configuration ID is validated. If the ID is invalid, the invalid
ID is displayed momentarily on the second line before the ID is displayed. If the ID is valid, then the ID is
stored in NVRAM and the printer automatically begins POR to activate the new setting.
Note: The printer begins POR in the normal mode, not in the diagnostic mode.
Note: If a configuration ID has not been set, and Check Configuration ID displays, then upon entry into
Diagnostics mode, Configuration ID is the only diagnostic function displayed until a valid ID is entered.
Edge to Edge
Turn Edge to Edge printing on or off.
Perm Page Count
=1234567*
Configuration ID
=1234567*
To Next Page
Loading...
