4-6 Service Manual
5060-4xx
Removal procedures
CAUTION: Remove the power cord from the printer or electrical outlet before you connect or
disconnect any cable or electronic board or assembly for personal safety and to prevent damage to
the printer. Disconnect any connections between the printer and PCs/peripherals. The C76xn
weighs approximately 47.7 kg (105 lb) and requires at least two people to lift it safely. Make sure
your fingers are not under the printer when you lift or set the printer down.
Note: Some removal procedures require removing cable ties. You must replace cable ties during reassembly to
avoid pinching wires, obstructing the paper path, or restricting mechanical movement.
Top cover assembly
Go to “Top cover assembly” on page 7-3 for part number.
1. Remove the redrive cap.
2. Remove the right light shield screw (A) type “324” on page 4-5 and screw (B) “323” on page 4-3. Also
release (C).
To Next Page
Loading...
