Repair information 4-69
5060-4xx
Registration motor
1. Remove the system board shield.
2. Remove the registration motor mounting screws (B), cut the cable tie (A), and remove the assembly.
RIP fan
Go to “RIP fan, 92 mm” on page 7-35 for part number.
1. Remove the rear cover. See “Rear cover” on page 4-16.
2. Remove the two rip fan rear screws (A).
3. Remove the front rip fan screw (B)
4. Disconnect the rip fan cable from the system board at connector J3.
5. Remove the rip fan.
A B(323)A(324)
To Next Page
Loading...
