Repair information 4-55
5060-4xx
Paper size sensing assembly
Go to “Paper size sensing” on page 7-16 for part numbers associated with this assembly.
1. Enter Diagnostics mode. Power up the printer in Diagnostics mode (holding Go and Return until
Performing Self Test appears.).
2. Print the Quick Test Page, if possible. Retain this sheet to verify the installation.
a. Select REGISTRATION.
b. Press Go to print the page.
3. Turn the printer off.
4. Remove the inner system board shield. See “Inner system board shield” on page 4-43.
5. Open the waste toner container door and slide the container out.
6. Remove the two screws (A) on the lower shield and remove the ground wire screw (B).
7. Remove screw (C) from the paper size sensing assembly.
To Next Page
Loading...
