Repair information 4-43
5060-4xx
Inner system board shield
Go to “System board shield assembly with clips” on page 7-33 for part number.
1. Remove the top cover assembly. See “Top cover assembly” on page 4-6.
2. Remove the rear cover. See “Rear cover” on page 4-16.
3. Remove the transfer HVPS board. See “Transfer HVPS board” on page 4-73.
4. Remove the system board. See “System board” on page 4-72.
5. Remove ground wire screw (A) and the cable straps (B).
6. Remove the five screws (C).
7. Lay the inner system board shield out of the way.
Note: If you need to remove the toroid, unclip the fastener.
To Next Page
Loading...
