Diagnostic aids 3-11
5060-4xx
Energy Conserve
When Energy Conserve is on, the customer does not have access to disable the Power Saver function. When
Energy Conserve is off, Disable appears as an additional menu item in the Power Saver menu. This setting only
affects the values that are displayed in the Power Saver Menu.
1. Select Energy Conserve from the Config Menu.
2. Select On or Off.
Auto Color Adjust
Automatic color adjustments periodically occur during printing, based on internal algorithms The following
situations prompt the adjustment:
• If the printer detects a new or different color cartridge is installed, usually at power on or when the cover is
closed.
• If the printer detects a new or different ITU is installed, usually at power on or when the cover is closed.
• If the fuser detects at power on that the fuser temperature is at 60° C.
• If Power Saver has been active for eight hours or more.
• If the printer was turned off during a calibration cycle.
• At the Ready state, if one of several internal engine parameters has exceeded a given threshold.
• If requested by the user from the operator panel or by a PJL command.
• At the Ready state if more than 500 pages are printed since the last calibration. This value can be adjusted
in this menu.
Selecting Off disables all Auto Color Adjust prompts listed above except the request of the user or the PJL
command.
1. Select Auto Color Adjust from the Config Menu.
2. Select Off or a value from 100 to 1000. The default value is 500.
Use Menu to increase the value.
The values are in increments of 50. The default is 500 pages. The number refers to how many pages since the
last calibration before recalibration begins automatically.
ERROR LOG
The history of printer errors can be printed by selecting Print Log.
Note: This log can be printed from Diagnostics mode or the Configuration Menu, but the report from
Configuration menu contains the debug and secondary error codes that do not print version from the
Diagnostics mode. The errors printed here do not necessarily match in number or in order those printed with
Display Log in Diagnostics. However, you can select additional options in Diagnostics mode, including Display
Log and Clear Log. For additional information, see “ERROR LOG” on page 3-35. Errors are also shown on the
Print Quality Pages.
Font Sharpening
Font Sharpening allows the user to adjust the value of the high frequency screens used for font data. For
example, if the value is 24, all fonts 24 points and less use the high frequency screens.
1. Select Font Sharpening from the Config Menu.
2. Select a value from 1 to 150. The default value is 24.
Use Menu to increase the value.The increment is 1.
This feature only works in PostScript emulation.
To Next Page
Loading...
