3-36 Service Manual
5060-4xx
Clear Log
To clear the Error Log:
1. Select Clear Log from ERROR LOG in the Diagnostics mode.
2. Select Yes to clear the Error Log or No to exit the Clear Log menu.
If Yes is selected, the Empty Error Log displays on the screen.
3. Press Return or Stop to exit the Clear Log menu.
EXIT DIAGNOSTICS
Select EXIT DIAGNOSTICS to exit the Diagnostics mode and return to normal mode.
HCIT standalone test mode
This test lets you check out and test the HCIT (2000-Sheet High Capacity Input Tray) without removing any
option or the base printer mounted above the optional HCIT.
Note: During normal operation, the red LED on the HCIT system board blinks on for one second and off for one
second.
Dip switch settings
Do the following steps to set and run the Test/Diagnostic:
1. Use the Dip Switch Settings table to determine the settings (DSW1 thru DSW4) on the HCIT control board
for the test you want to run.
2. Turn the HCIT power off by moving the LVPS slide switch to the left position.
3. Press and hold the Push Button Switch PBSW1 while moving the LVPS slide switch to the right position.
The red LED on the HCIT control board comes on.
4. Press PBSW1 to feed paper.
5. Press PBSW1 to stop feeding paper.
Dip switch settings
DSW1 DSW2 DSW3 DSW4 Mode
Off Off Off N/A Set for shipping
Off Off On N/A The Mirror Reflection Sensors must be adjusted anytime the
sensors are replaced.
Off On Off N/A EEPROM Initialize
Off On On N/A Not used
On Off Off N/A Paperless Operation Mode
On Off On N/A Self Operation Mode
On On Off N/A Standalone Feeding Operation Mode
On On On N/A Not used
To Next Page
Loading...
