Appendix A—Service tips A-7
5060-4xx
Finisher alignment
This tip provides detailed instructions for aligning the finisher to the printer.
The sides of the finisher must be parallel with the printer and at the same height, or you may have paper feeding
problems.
There are four locations where adjustments can be made to correctly align the finisher with the printer. There are
two adjustment casters on the left (the side closest to the printer) and two on the right, underneath the platform
cover.
Note: The short finisher left casters adjust with caster bolts, while the tall finisher left casters adjust with
wingnuts.
How the casters are adjusted depends on whether you have the short or tall finisher.
• Short finisher
– Printer
– Optional duplex unit
– Three additional 500-sheet drawers
– Printer stand
– Finisher
Finisher
Printer
Duplex unit
500-sheet
drawers
Printer stand
To Next Page
Loading...
