6-4 Service Manual
5060-4xx
Scheduled maintenance
The operator panel displays 80 Fuser Maintenance and 83 ITU Maintenance for scheduled maintenance.
80 Fuser Maintenance is displayed at each 200,000 copies when the fuser assembly needs to be replaced to
maintain the print quality and reliability of the printer. The parts are available as a maintenance kit with the
following part numbers:
Standard fusers
• 56P2910, Maintenance kit 115 V fuser
• 56P2911, Maintenance kit 220 V fuser
• 56P2912, Maintenance kit 100 V fuser
Web oiler fusers and web oiler replacements
The web oiler fuser has a life of approximately 200,0000 copies, but the web oiler life is about 100,000.
• 12G6524, Fuser assembly, web oiler 115 V 500W
• 12G6525, Fuser assembly, web oiler 220 V 500W
• 12G6499, Fuser assembly, web oiler 100 V 500W (Japan)
• 12G6545, Web oiler assembly
83 ITU Maintenance is displayed at each 120,000 copies when the ITU Assembly needs to be replaced to
maintain the print quality and reliability of the printer. There are two assemblies, ITU assembly and Second
Transfer Roll, in a maintenance kit. Both should be replaced at the same time. The parts are available as a
maintenance kit with P/N 56P2848, ITU Maintenance Kit.
After replacing the kit, the fuser maintenance count must be reset to zero to clear the maintenance message.
84 Oiler Nearly Exhausted is displayed at each 100,000 copies when the Web Oiler Assembly is nearly
exhausted. Go to “Web Oiler Assembly” on page 7-9 for part number.
To Next Page
Loading...
