Repair information 4-61
5060-4xx
Printhead mechanical alignment
Warning: Do not loosen or remove all printheads at the same time. If all printheads are loosened or removed,
your reference to readjust will be lost.
1. Install two printhead alignment assemblies, one in the front and another in the rear (see Figure 2 and
Figure 3), by aligning the locating pin on the printhead alignment bracket (see Figure 1) with the hole in the
printer frame.
2. Attach the printhead alignment tool with the provided screw.
Thumbwheel Bracket Locating pin
Figure 1
To Next Page
Loading...
