Repair information 4-29
5060-4xx
Cartridge contact assembly
Go to “Cartridge contact assembly” on page 7-28 for part numbers.
Warning: Do not remove printheads.
1. Open the front cover.
2. Remove the toner cartridges.
3. Remove the ITU assembly. See “ITU assembly” on page 4-44.
4. Remove the top cover assembly. See “Top cover assembly” on page 4-6.
5. Remove the developer HVPS board. See “Developer HVPS board” on page 4-31.
6. Remove the cartridge rail front and rear mounting screws and remove the rail of selected cartridge
assembly.
7. Press the cartridge contact assembly (yellow shown) retaining tabs (A) and remove the assembly.
8. Remove the screw (B) from the front of the printhead.
9. Remove the screws for the contact assembly you are removing.
To Next Page
Loading...
